Measurement-computing USB-TEMP-AI Manual do Utilizador descarregar pdf (Página 25)

USB-TEMP-AI User's Guide Specifications

Settling time is defined as the time required for a channel to settle within a specified accuracy in response to a

full-scale (FS) step input.

Analog input calibration

Table 13. Analog input calibration specifications

Parameter

Specifications

Recommended

warm-up time

30 minutes min

Calibration

Firmware calibration

Calibration interval

1 year

Calibration

reference

+10.000 V, ±5 mV max. Actual measured values stored in EEPROM

Tempco: 5 ppm/°C max

Long term stability: 30 ppm/1000 h

Throughput rate

Table 14. Throughput rate specifications

Number of Input

Channels

Maximum throughput

2 Samples/second

2 S/s on each channel, 4 S/s total

2 S/s on each channel, 6 S/s total

2 S/s on each channel, 8 S/s total

2 S/s on each channel, 10 S/s total

2 S/s on each channel, 12 S/s total

2 S/s on each channel, 14 S/s total

2 S/s on each channel, 16 S/s total

Note 18: The analog inputs are configured to run continuously. Each channel is sampled twice per second.

The maximum latency between when a sample is acquired and the voltage/temperature data is

provided by the USB unit is approximately 0.4 seconds.

Digital input/output

Table 15. Digital input/output specifications

Parameter

Specification

Digital type

5V CMOS

Number of I/O

8 (DIO0 through DIO7)

Configuration

Independently configured for input or output.

Power on reset is input mode unless bit is configured for alarm.

Pull-up/pull-down

configuration

All pins pulled up to +5 V via 47 K resistors (default). Contact MCC factory for

pull-down to ground (GND) capability.

Digital I/O transfer rate

(software paced)

 Digital input – 50 port reads or single bit reads per second typ

 Digital output – 100 port writes or single bit writes per second typ

Input high voltage

2.0 V min, 5.5 V absolute max

Input low voltage

0.8 V max, –0.5 V absolute min

Output low voltage

(IOL = 2.5 mA max)

0.7 V max

Output high voltage

(IOH = –2.5 mA max)

3.8 V min

1 2 ... 20 21 22 23 24 25 26 27 28 29 30

Comentários a estes Manuais

Sem comentários

Measurement-computing USB-TEMP-AI Manual do Utilizador Página 25

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Measurement-computing USB-TEMP-AI