Measurement-computing WLS-IFC Manual do Utilizador

WLS-IFC USB-to-Wireless Interface Document Revision 5 April 2014 © Copyright 2014 User's Guide

WLS-IFC User's Guide Functional Details 10 Power LED The Power LED is lit when the WLS-IFC is connected to a computer or external USB hub. USB c

11 Chapter 4 Specifications All specifications are subject to change without notice. Typical for 25°C unless otherwise specified. Specifications in i

WLS-IFC User's Guide Specifications 12 USB +5V voltage Table 4. USB +5V voltage specifications Parameter Specification USB +5V (VBUS) input volt

WLS-IFC User's Guide Specifications 13 LED configuration Table 9. LED configuration Parameter Specification Power The WLS-IFC is connected to a

Declaration of Conformity Manufacturer: Measurement Computing Corporation Address: 10 Commerce Way Suite 1008 Norton, MA 02766 USA Category

Measurement Computing Corporation 10 Commerce Way Suite 1008 Norton, Massachusetts 02766 (508) 946-5100 Fax: (508) 946-9500 E-mail: [email protected]

2 HM WLS-IFC.docx Your new Measurement Computing product comes with a fantastic extra — Management committed to your satisfaction! Thank you for choo

3 Table of Contents Preface About this User’s Guide ...

4 Preface About this User’s Guide This user's guide describes the Measurement Computing WLS-IFC data acquisition interface device and lists devi

5 Chapter 1 Introducing the WLS-IFC Overview: WLS-IFC features The WLS-IFC is a USB-to-wireless interface module that is supported under popular Micr

6 Chapter 2 Installing the WLS-IFC What comes with your WLS-IFC shipment? The following items are shipped with the WLS-IFC. Hardware  WLS-IFC  U

WLS-IFC User's Guide Installing the WLS-IFC 7 If you use a hub of this type without connecting to external power, communication errors may occur

WLS-IFC User's Guide Installing the WLS-IFC 8  CH: The radio frequency (RF) channel number assigned to the device. The channel number is used

9 Chapter 3 Functional Details External components The WLS-IFC has the following external components, as shown in Figure 3.  Status LEDs (USB Activ