Measurement-computing eZ-PostView rev.2.0 Manual do Utilizador descarregar pdf (Página 97)

eZ-Analyst 969795 Edit Menu 4-19

Understanding Total Measured Data

In this figure, the Start Recording panel’s PreAcq-Trigger data and the Stop Recording Panel’s

Trigger Delay data are both saved as part of the total measured data.

Edit Menu > Configuration > Recording Setup Tab: Stop Recording Panel

Provide a means of setting the following parameters that pertain directly to stop recording:

Recording Duration sets a “time-out” which the recording event is not to exceed. If an

acquisition has been triggered, the measurement will run until either (a) the amplitude-based

Enable Stop Trigger Condition is met, or (b) the Recording Duration is met, whichever occurs

first. When the Recording Duration value is met, the recording event is aborted.

Note: Entering a value of “0” in the Recording Duration block sets the duration to infinity.

Enable Stop Trigger – if the checkbox is checked, amplitude-based data can be set as a

stop condition for the recording. The following options are provided.

Amplitude-Based

Data Types

Peak Time >=

Peak Time <

Spectrum >=

Spectrum <

at specified frequency

Delay (sec) – this function is used to include [with the recording] data that follows the stop

trigger event by the set number of seconds, as specified by the delay.

Maximum Duration Limit Terminating a Measurement

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 143 144

Sem comentários

Measurement-computing eZ-PostView rev.2.0 Manual do Utilizador Página 97