Measurement-computing DASYLab Getting Started Manual do Utilizador

Getting Started Using DASYLab with a Measurement Computing DAQ Device

Exercise: Acquiring, displaying, and writing analog data 10 Add a Y/t Chart module You can use a display module such as a Y/t Chart module to display

Exercise: Acquiring, displaying, and writing analog data 11 Configure the data file The Write Data module has numerous properties you can set that de

Exercise: Acquiring, displaying, and writing analog data 12 Acquire, display, and write data After setting up the data acquisition operation, run the

Exercise: Acquiring, displaying, and writing analog data 13 DEMO-BOARD and USB-1608FS-Plus examples are shown next. Excel file of DEMO-BOARD data with

Technical support 14 Technical support Additional information about DASYLab is available on our website at www.mccdaq.com. You can also contact Measur

Measurement Computing Corporation 10 Commerce Way Norton, Massachusetts 02766 Tel: (508) 946-5100 Fax: (508) 946-9500 www.mccdaq.com *325662D-01* 32

Trademark and Copyright Information Measurement Computing Corporation and the Measurement Computing logo are either trademarks or registered tradema

3 Table of Contents Introducing the MCC driver for DASYLab ... 4 System requirements .

Introducing the MCC driver for DASYLab 4 Introducing the MCC driver for DASYLab Thank you for purchasing DASYLab from Measurement Computing Corporatio

Install InstaCal 5 Operating systems You must have administrator rights on your account using one of the following operating systems:  Windows® 8 64

Run InstaCal and add your MCC device 6 Run InstaCal and add your MCC device To run InstaCal and add an MCC device to the InstaCal configuration, compl

Run InstaCal and add your MCC device 7 3. Follow the instructions and click Next on the next three setup dialog boxes to select the installation direc

Exercise: Acquiring, displaying, and writing analog data 8 Exercise: Acquiring, displaying, and writing analog data You can acquire, display, and writ

Exercise: Acquiring, displaying, and writing analog data 9 3. Double-click on the Analog Input module to open its module dialog box. By default, analo