Measurement-computing Analyzer488 Manual do Utilizador descarregar pdf (Página 181)

100

101

Section 4 Serial Controller

4.87

TIMEOUT

The

TIMEOUT

command sets the number of seconds that the Analyzer488 will

wait for a bus event before declaring a time out error. The Analyzer488 checks for

time out errors on every byte it transfers, including command bytes. When using the

KEY

command, the Analyzer488 will wait the

TIMEOUT

period for a keypress.

Time out checking may not be suppressed however it may be set to a maximum

time of about 18 hours.

The query command

TIMEOUT?

returns the current timeout value.

TYPE System command

SYNTAX TIMEOUT[;][n]

is the number of seconds to allow in the range of 1 to 65535.

RESPONSE None

MODE Any

BUS STATES None

QUERY The string

TIMEOUT

followed by the timeout value.

RESPONSE

EXAMPLES

PRINT#1,"TIME OUT 10"

Wait 10 sec before time out

PRINT#1,"TIME OUT 3600"

Wait an hour before time out

1 2 ... 176 177 178 179 180 181 182 183 184 185 186 ... 280 281

Comentários a estes Manuais

Sem comentários

Measurement-computing Analyzer488 Manual do Utilizador Página 181

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Measurement-computing Analyzer488