Measurement-computing E-PDISO16 Manual do Utilizador descarregar pdf (Página 11)

E-PDISO16 User's Guide Installing the E-PDISO16

Unpacking the E-PDISO16

As with any electronic device, you should take care while handling to avoid damage from static

electricity. Before removing the E-PDISO16 from its packaging, ground yourself using a wrist strap or by

simply touching the computer chassis or other grounded object to eliminate any stored static charge.

If your E-PDISO16 arrives already damaged, notify Measurement Computing Corporation immediately by

phone, fax, or email. For international customers, contact your local distributor where you purchased the E-

PDISO16.

! Phone: 508-946-5100 and follow the instructions for reaching Tech Support.

! Fax: 508-946-9500 to the attention of Tech Support

Installing the software

Refer to the Quick Start Guide for instructions on installing the software on the Measurement Computing Data

Acquisition Software CD. This booklet is available in PDF at www.mccdaq.com/PDFmanuals/DAQ-Software-

Quick-Start.pdf.

Connecting the external power supply

Power to the E-PDISO16 is provided with the +9 V, 3 A external power supply (CB-PWR-9V3A). It does not

matter if you connect the external power cable before or after you connect the Ethernet cable. To connect the

power supply to your E-PDISO16, do the following.

Connect the +9 V DC power supply cord to the connector labeled

POWER IN on the E-PDISO16 enclosure

(

IN on the module). Refer to on page 3-1 for the location of this connector. Figure 3-1

Plug the power cord into an electrical outlet.

The

POWER LED illuminates when +9 V power is supplied to the E-PDISO16. If the voltage supply is less

than +6.0 V or more than +12.5 V, the

POWER LED does not light.

Do not connect external power to the POWER OUT connector

The power connector labeled POWER OUT on the enclosure (OUT on the module) is used to power an

additional Measurement Computing product. If you connect the external power supply to the POWER OUT

connector, the E-PDISO16 does not receive power, and the POWER LED does not illuminate.

Connecting the Ethernet cable

Your computer communicates with the E-PDISO16 remotely via the Ethernet cable. To connect the Ethernet

cable to the E-PDISO16 and to the network, do the following:

Connect the Ethernet cable to the Ethernet communication port on the E-PDISO16.

Use a standard Ethernet CAT-5 shielded or unshielded twisted pair Ethernet cable.

Plug the cable into your network's Ethernet connection.

The

LINK LED illuminates steady green to indicate that you have established an Ethernet connection

between your E-PDISO16 and the network.

2-2

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Sem comentários

Measurement-computing E-PDISO16 Manual do Utilizador Página 11