Measurement-computing DAQ Quick Start Manual do Utilizador descarregar pdf (Página 10)

Configure and test the DEMO-BOARD with InstaCal

You can configure and test the DEMO-BOARD with InstaCal.

Note: For physical MCC devices, common DAQ options include

selecting a single-ended or differential channel configuration, and

selecting the voltage range to acquire. Configuration and testing

options vary depending on the type of device and the features it

offers.

Configure channel 0

In the following example, use InstaCal to change the configuration of

channel 0 on the DEMO-BOARD.

1. On the PC Board List, double-click DEMO-BOARD.

2. Select Damped Sine Wave from the Ch. 0 list on the Board

Configuration

dialog box and click OK.

Test channel 0

InstaCal includes options to test the analog and digital features of your MCC

hardware. When running internal tests, disconnect your signals or your cable

to prevent false failures.

Complete the following steps to run the analog loop back test on the

DEMO-BOARD and verify that the channel is generating the proper

waveform.

1. Select the DEMO-BOARD on the PC Board List.

2. Select Test»Analog and select Ch 0 in the Input Ch list.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Sem comentários

Measurement-computing DAQ Quick Start Manual do Utilizador Página 10