Measurement-computing WaveBook rev.4.0 Manual do Utilizador Página 20

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 19
2-10 An Introduction to WaveBook
05-22-01
WaveBook Users Manual
PGA Filter
Filter Type:
20KHz low pass, Butterworth, 5-pole filter
WBK11A Functions
Input Voltage Ranges:
Software programmable prior to a scan sequence
Aperture Uncertainty (SSH):
75ps max
Voltage Droop (SSH):
0.01mV/ms typ
WBK12A/13A Functions
Input Voltage Ranges:
Software programmable prior to a scan sequence
Low Pass Filter Type:
Software selectable, 8-Pole elliptic or linear phase
Anti-Aliasing Filters:
Single-pole pre and post filters, automatically set depending on filter frequency selected
Low-Pass Filter Frequency Cutoff Range:
100KHz, 75KHz, 60KHz400Hz, bypass (fc=300KHz/N where N=3 to 750
Filter Grouping:
4 Channels each in two programmable banks
Aperture Uncertainty (SSH):
75ps max
Voltage Droop (SSH):
0.01mV/ms typ
Triggering
Channel 1 Analog Trigger
Input Signal Range:
-10 to +10V
Input Characteristics and Protection:
Same as channel inputs
Latency:
300ns
Multi-Channel Analog Trigger (up to 72 channels):
Range:
Selectable per channel to input range
Latency:
2us/channel, plus 4us maximum
TTL Trigger:
Input Signal Range:
0-5V
Input Characteristics:
TTL-compatible with 10K ohm pull-up resistor
Input Protection:
Zener clamped 0.7 to +5V
Latency:
300ns
Software Trigger
Latency:
100us typical
Pulse Trigger
Input Signal Range:
0-5V
Input Characteristics:
75 ohms
Input Protection:
±
10V maximum
Minimum Pulse Width:
100ns
Latency:
300ns
External Clock
Connector:
Available on DB25 digital input
Input Signal Range:
5V TTL compatible
Input Characteristics:
50K ohms pull up (to +5V) in parallel with 50pF
Input Protection:
Zener clamped 0.7 to +5V
Delay: 200ns
Signal Slew Rate Requirement:
20V/us minimum
Rate:
Up to 1MHz
Divisor ratio:
Divide by 1 through 255, selectable
Clock Counter Accuracy:
<0.02% error
Clock Counter Range:
0.01Hz to 100KHz
Vista de página 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 81 82

Comentários a estes Manuais

Sem comentários