Measurement-computing eZ-Balance rev.9.0 Manual do Utilizador descarregar pdf (Página 8)

1-4 Installing and Running the Application 978691 eZ-Balance

Connecting the Data Acquisition Device

Refer to your hardware documentation in regard to connecting hardware and signal lines; and in regard to

product specifications.

Hardware documents, in PDF format, can be obtained from the following locations:

Directly from the installation CD (select “Manuals” from the CD’s splash screen)

From the online Tech Support section at www.iotech.com

From the Programs group on your CD, providing that you installed your software from a CD

Note that ZonicBook/618E, WaveBook/516 Series, and IOtech 600 Series devices are configured entirely

via software.

In regard to connecting sensors, the following table may prove useful as a general guide.

Sensor Type

Single-Ended (SE)

or Differential

Coupling

ICP

Proximity

DC*

OFF

Accelerometer/Velocity

ON or OFF

Depending on the instrument

Tach

OFF

*Typically, Proximity and DC proportional signals should be DC coupled.

At this point you should be ready to look at the steps required for a balancing project. These are presented

in the next chapter.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 39 40

Sem comentários

Measurement-computing eZ-Balance rev.9.0 Manual do Utilizador Página 8