Measurement-computing WBK40 Manual do Utilizador descarregar pdf (Página 24)

You will need the following:

Phillips Screwdriver •

•

3AG Fuse Puller, or needle-nose pliers*

3/16-inch hex-nut driver

Grounding wrist strap and associated anti-static pad

Replacement fuse F201

Needle-nose pliers can be used to pull MINI ATO fuses; but should not be used to insert fuses.

Observe the Caution and the important note on page 23 of this document module prior to

beginning this fuse replacement procedure.

1. If you have not already done so, turn OFF the power to, and UNPLUG the WBK40 or WBK41 module

and all connected equipment. Remove all signal I/O lines from the unit.

2. Remove the Jackscrews from the P1 and PARALLEL PORT connectors. In addition, WBK41 users must

remove Jackscrews from the P2 connector. The following figure shows the screw locations.

3. Using a Phillips screwdriver, remove the two Rear Panel Screws and the Bottom Panel Screw.

Rear Panel Screw P1 and P2 Jackscrews* Rear Panel Screw

WBK41 Rear Panel, Screw Removal

WBK40 has no P2 connector

Bottom Panel Screw

Parallel Port Jackscrews

4. Remove the Rear Panel from the rest of the chassis.

F201 Fuse Location

pg. 24, WBK40 & WBK41

926896

Thermocouple and Multifunctional Modules

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 33 34

Sem comentários

Measurement-computing WBK40 Manual do Utilizador Página 24