Measurement-computing 6K-SSR-RACK08 Manual do Utilizador Página 27

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 33
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 26
6K-SSR-RACK08 User's Guide Specifications
Power in jumper (JP1)
Table 6. JP1 specifications
+5PC
Use cable C-PCPOWER-10
+9V EXT Use Adapter CB-PWR-9
+5 BD (default) Powered from 100-pin connector
I/O module type selection (JP2, JP3)
Table 7. JP2 and JP3 specifications
Modules 1-4
Selectable via JP2 as either input modules or output (default) modules. Do not
mix input and output modules within this bank of four.
Modules 5-8
Selectable via JP3 as either input modules or output (default) modules. Do not
mix input and output modules within this bank of four.
Pull-up/pull-down on digital I/O lines Configurable at RN1 with 2.2 K resistor network. Not populated by default.
I/O module polarity selection (JP5, JP6)
Table 8. JP5 and JP6 specifications
Modules 1-4
Inverted (active high) or non-inverted (active low, default), selectable via JP5.
Modules 5-8 Inverted (active high) or non-inverted (active low, default), selectable via JP6.
Bypass resistors
Table 9. Bypass resistor specifications
Resistors R1 – R8
(Normally 0 )
Transceiver bypass resistors for bit-wise I/O configuration. NOT populated by default. Bypass
resistors are mutually exclusive of 74LS245 and 74LS640 transceivers.
Compatible products
Table 10. Compatible product specifications
Analog input boards PCI-DAS6013
PCI-DAS6014
PCI-DAS6030
PCI-DAS6031
PCI-DAS6032
PCI-DAS6033
PCI-DAS6034
PCI-DAS6035
PCI-DAS6036
PCI-DAS6052
PCI-DAS6023
PCI-DAS6025
PCI-DAS6040
PCI-DAS6070
PCI-DAS6071
Analog output boards PCI-DAC6702
PCI-DAC6703
Note 1: The 6K-SSR-RACK08 requires external power (for all products above) when used with the
C100HD50 (pins 51-100) ribbon cable.
4-2
Vista de página 26
1 2 ... 22 23 24 25 26 27 28 29 30 31 32 33

Comentários a estes Manuais

Sem comentários