Measurement-computing 6K-ERB08 Manual do Utilizador descarregar pdf (Página 18)

6K-ERB08 User's Guide Installing the 6K-ERB08

Figure 2-4. 6K-ERB08 board jumpers and external power connectors

Power source

Set the power source with jumper JP1 (labeled POWER IN). You can power the 6K-ERB08 using one of the

following sources.

 The 6000 Series control board’s internal +5 V power supply (default)

 Your computer’s +5 V power supply, or external +5 V supply (power cable supplied)

 AC adapter (supplied)

Figure 2-5

Figure 2-5. Power source jumper JP1configurations

shows the

POWER IN jumper setting for each power source.

+5BD

Internal power

from the MCC board

External power from

the computer’s power supply

+5PC

External power from

an AC adapter

9V EXT

Internal power

from the MCC board

External power from

the computer’s power supply

External power from

an AC adapter

External +5 V PC power connections

You can power the 6K-ERB08 with your computer’s +5 V power supply using the

C-PCPOWER-10 cord that

was shipped with the board. Each end of the cable has a keyed MOLEX type connector. To connect to your

computer’s internal power connectors, do the following:

Turn your computer off, remove the cover, and insert your board into an available PCI slot.

Close your computer and turn it on.

Turn off power to the computer and remove the cover.

Connect one end of the C-PCPOWER10 power cord to one of your computer’s internal power connectors.

If necessary, refer to your computer's user manual for the location of the power supply connectors.

Run the power cable out the back of the computer through an expansion slot or other opening, and replace

the cover on the computer.

2-9

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Sem comentários

Measurement-computing 6K-ERB08 Manual do Utilizador Página 18